Download UP 3 Hardware Reference Manual

Transcript
UP3 Education Kit
Power
Supply
Circuitry
Power Supply Circuitry
The UP3 board is powered with number of different regulated supply
voltages.
1. +1.5 Volt is for Cyclone core supply.
2. +3.3 Volt is for Cyclone I/O ring supply.
3. +5 Volt is for 5volt operative devices on the board.
The board accepts +9 Volt unregulated/regulated supply from external source (with center-terminal positive supply).
Debug headers provided for the power supply on the board are
described in Table 26.
TABLE 26. Headers on the board
Header
Purpose
JP6
+5 V regulated supply
JP7
+3.3 V regulated supply
JP8
Unregulated input voltage to the board
JP10
+1.5 V regulated supply
Power Supply Configuration Jumper
The board is provided with jumper setting for input supply to the
board. Jumper pins JP5.2 and JP5.3 are shoted when input supply
from external source is +9 volt regulated/unregulated, which is
default setting on the board. Jumper pins JP5.1 and JP5.2 are shoted when input supply from external source is +5 volt regulated. The
second setting is useful when the 5 Volt regulator chip is not stuffed
on the board.
54
System Level Solutions