Download - NavCom Technology Inc.

LAND-PAK™ User Guide – Rev. C
Figure 14: Explorer 600+ Charger Connection
3. Plug the battery charger into an AC receptacle.
The CHG LED on the Explorer 600+ front panel
illuminates green (see Figure 15).
Figure 15: CHG LED
‡
The 9-pin male connector end of the
charging cable is not used in this
procedure.
4. Charge the battery until the green CHG LED
blinks (approximately four hours).
5. Unplug the battery charger and disconnect the
charging cable from the Explorer 600+.
Verify functionality:
to
6. Press the Explorer 600+ power button
boot up the Windows CE desktop. The icon for
Carlson SurvCE is on the desktop (see Figure
52).
7. Shut down Windows CE. Press and hold the
Explorer 600+ power button for at least 10
seconds.
4-56