Download Industrial MicroServer EIS-2B

4.11.3 Device Setting and Configuration
Device setup requires:
• Entering the IP address for iServer device (for example 128.100.101.98).
• Specifying Socket number (1000 for iServer).
• Defining RS485 Unit # serial interface address (1 to 199). Enter "0" for RS232 interface.
• Entering Reading command. Normally set to X01 to obtain reading from the devices.
• Defining the Alarm setup (High/Low, High value, or Low value).
• Specifying Pause Interval. It determines how many seconds each subsequential alarm
notification will be sent.
• Determining Monitor interval. It establishes the interval or time resolution in seconds
for which readings will be obtained from the device.
Figure 4.33 iServer Mail Notifier Device Setting
37