Download AirAccess - Spirent Knowledge Base

114 | AirAccess C2K User Manual
7.2.1.
Mobile Terminated SMS
Mobile terminated SMS is performed by first selecting the SMS Point-to-Point
Transport Layer Message. One of the following Teleservices is then selected:
•
Wireless Paging Teleservice (CPT-95)
•
Wireless Messaging Teleservice (CMT-95)
•
Voice Mail Notification (VMN-95)
Reply and Bearer Data options can then be specified, including User Data text.
To send the SMS message on the Paging Channel, click Send SMS Message while in
the Idle State to generate the message to the mobile station.
To send the SMS message on the Forward Traffic Channel, an SMS call must first be
established. This can be accomplished by performing the following steps:
Ensure that an SMS service option (SO6 or SO14) is the primary service option
configured in the Configure Service Negotiation window (see Section 4.8)
Verify the mobile station has registered (see Section 3.6)
Generate a mobile terminated call by selecting Call>Initiate MS-Terminated Call or
selecting Initiate MS-Terminated Call from the right-click menu of a BSC icon
After the call completes, verify the selected SMS service option is active as indicated
in the Test Results window
Click Send SMS Message to send the SMS message on the traffic channel
End the call by selecting Call>End Call or selecting End Call from the right-click menu
of the BSC icon
Contents of the SMS message and the mobile station’s response are displayed in the
Test Results window.
7.2.2.
Mobile Originated SMS
NOTE: Prior to performing Mobile Originated SMS testing, it is important that the
mobile station first identifies itself to AirAccess. This can be accomplished by
forcing a mobile station registration (Call>Force MS Registration).
Mobile originated SMS can be performed at any time after the mobile station has
identified itself to AirAccess. The contents of any SMS message received by AirAccess
from the mobile station, as well as the acknowledgement message sent back to the
mobile station, are displayed in the Test Results window.
The contents of the acknowledgement message can be customized by selecting the
SMS Acknowledge Transport Layer Message. Once this message is selected, the Error
Class and Cause Code parameters returned to the mobile station can be configured.