Download PDF - Classic Industries

Performance Ignition
NEVER CHANGE
POINTS AGAIN!
Ignitor shown
here installed
by
Pertronix
PX3000
PX3002
Flame Thrower 50,000 Volt HEI Coils
30 Month
Limited
Warranty
Eliminates points and moving parts that wear out,
while delivering twice the voltage to the spark plugs
over stock to increase horsepower, fuel economy
and plug life! Optimal performance can be achieved
when used with the Flame Thrower 40,000 volt coil.
Ignitor is concealed entirely within the distributor so
you have no unsightly black box to clutter up your
engine compartment. Easily installs in minutes with no
complex wiring, is compatible with 12-volt negative
ground systems, and it’s smog legal in all 50 states and
Canada! Comes with a 30-month warranty.
6 Cylinder
PX1168
1941-62 6 cylinder ......... 94.99 set
PX1162A
1963-74 6 cylinder ......... 81.99 set
8 Cylinder with Point-Lobe Style Sensor
PX1181LSC 1957-74 8 cylinder ......... 81.99 set
8 Cylinder with Hall-Effect Style Sensor
PX1181
1957-74 8 cylinder ......... 79.99 set
Pertronix Flame Thrower 50,000 volt E-Core coils
feature an optimized winding design to maximize spark
gap current and available voltage. When teamed with
the Flame Thrower module, they produce 100% more
energy across the spark plug gap compared to the OEM
coil. Select the matching Flame Thrower module for
your application to create a proven performance combo!
Note: Replaces OEM coils with the same color wires listed.
HEI In-Cap Mounted Coil
PX3000 black/yellow/red wire ............... 44.99 ea
PX3001 black/white/red wire ................. 49.99 ea
HEI Remote Mounted Coil
PX3002 1985-95 .................................... 44.99 ea
Flame Thrower HV 60,000 Volt Coils
The Flame Thrower HV (high voltage) coil have an
E-Core design which is rated at a sizzling 60,000 volts
and operates with no degradation of energy throughout
the temperature ranges. Made from 6063 T5 aluminum,
it efficiently transfers heat to optimize energy output,
and the housing is black anodized for increased
corrosion resistance. Available in 3 different resistances
for compatibility with most points and electronic
ignition systems. Standard threaded connections and
mounting hardware are included.
PX60104 0.45 ohm ............................... 69.99 ea
PX60115 1.5 ohm ................................. 69.99 ea
PX60130 3.0 ohm ................................. 69.99 ea
Flame Thrower HC 60,000 Volt Coil
K
Engines & Components
The Ignitor II electronic ignition goes an extra step
beyond for even more power and efficiency! It senses
levels of current in the coil, and uses a powerful micro
controller to adjust the dwell to maintain peak energy
throughout the entire RPM range. As engine RPM and
operating conditions change, dwell time is increased
or decreased to provide more energy at higher RPM,
reducing misfires while improving engine performance.
Ignitor II develops nearly 4 times more available energy
between 3000 and 5000 RPM, and double the available
plug voltage! The Ignitor II’s higher RPM performance
is maximized when used with the new Flame-Thrower
II super low resistance (0.6 ohms) 45,000 volt coil,
but the system is compatible with any induction coil.
It comes with a 30-month warranty and is emissions
legal in all 50 states and Canada!
6 Cylinder
PX91162
1963-74 6 cylinder ......... 114.99 set
8 Cylinder with Hall-Effect Style Sensor
PX91181
1957-74 8 cylinder ......... 114.99 set
Ignition box performance without the box. The Ignitor
III is the most advanced points replacement set. It
is literally an ignition box inside your distributor. It
features multiple sparks throughout the entire RPM
range and a REV limiter accurate to +/- 50 RPM
which is set by you with an LED user feedback for rev
limit confirmation. The Ignitor III module generates 5
times more spark than points. This means more spark
energy creating more horsepower and better mileage.
The Ignitor III features include: adaptive dwell which
maintains peak energy throughout the entire RPM
range, reducing misfires while improving engine
performance. Peak current level is reached just prior to
spark for maximum energy without the heat build-up,
increasing coil performance and module reliability.
Legal in all 50 states and Canada. Fits GM V8 single
point type distributors.
Note: Not available for 6 cylinder.
PX71181
506
1957-74 ............................... 131.99 ea
Performance Ignition
PX45001
PX45011
PX45111
Flame Thrower Performance Coils
Complete your ignition upgrade with a Flame Thrower
high performance coil. Best when used with the Ignitor
Electronic Ignition Conversion, the Flame Thrower
Hi Performance Coil fits existing coil brackets for
a clean, factory look. Enables larger plug gaps for
greater fuel efficiency & more power. Available with
either a chrome or black finish. Choose from a variety
of voltages and primary resistance ratings.
40,000 Volt Coil - 1.5 & 3.0 ohm
These Flame Thrower coils are compatible with breaker
point ignition systems or vehicles equipped with the
original Ignitor system. Choice of 6 cyl or 8 cyl.
Chrome Oil Filled
PX40501 6 cyl 3.0 ohm .................... 35.99 ea
PX40001 8 cyl 1.5 ohm .................... 39.99 ea
Black Oil Filled
PX40511 6 cyl 3.0 ohm .................... 34.99 ea
PX40011 8 cyl 1.5 ohm .................... 34.99 ea
Black Epoxy Filled
PX40611 6 cyl 3.0 ohm .................... 41.99 ea
PX40111 8 cyl 1.5 ohm .................... 41.99 ea
45,000 Volt Coil - 0.6 ohm
The Flame Thrower II coils are for use on vehicles
equipped with the Ignitor II system.
Chrome Oil Filled
PX45001 4, 6 or 8 cylinder.................... 49.99 ea
Black Oil Filled
PX45011 4, 6 or 8 cylinder.................... 36.99 ea
Black Epoxy Filled
PX45111 4, 6 or 8 cylinder.................... 45.99 ea
45,000 Volt Coil - 0.32 ohm
The Flame Thrower III coils are for use on vehicles
equipped with the Ignitor III system.
Chrome Oil Filled
PX44001 8 cylinder .............................. 44.99 ea
Black Oil Filled
PX44011 8 cylinder .............................. 39.99 ea
The Flame Thrower HC (high current) coils have an
E-Core design which is rated at 60,000 volts with
an ultra low .32 primary resistance and has a High
Current design for a rapid charge rate. Made from
6063 T5 aluminum, it efficiently transfers heat to
optimize energy output. The housing is black anodized
for increased corrosion resistance and has a precision
machined male high tension terminal and brass primary
terminals. It is compatible with Ignitor II and Ignitor
III systems as well as most capacitive discharge
boxes. Standard threaded connections and mounting
hardware are included.
PX60103 0.32 ohm ............................... 69.99 ea
66944C
PX2000
PX20011
PX20021
Performance Ignition Modules
These performance ignition modules are direct
replacements for GM computer controlled distributors.
These modules provide enhanced high RPM
performance and increase spark plug voltage when
used with a corresponding Flame Thrower coil.
Pertronix Flame Thrower Modules
PX2000 1974-88 4 pin, 6.9 amp........ 49.99 ea
PX20011 1980-91 7 pin, 6.0 amp........ 54.99 ea
PX20021 1987-91 8 pin, 6.0 amp........ 51.99 ea
Proform Modules
66944C 1974-88 4 pin ...................... 19.99 ea
Toll Free Order Line 800.854.1280