Download Patterning Key - user manual

Grading
To use the Automatic Grading, the two base patterns must have the same number of
elements and the scaling points must be in the same direction and with the same
origin.
The identification data of the new patterns are taken from the smaller pattern, if it is
this the has. The data of the pattern increased, if the has, these are ignored, except for
the size.
The Automatic Grading command, requested firstly designating the minor pattern,
and then the larger pattern. Designated once the dialog box is displayed.
Table of sizes
In this list you select the sizing table applied in scaling the. It is only
active if the minor pattern has identification data.
The table of selected design must include the size of the smaller
pattern and the by the largest if it has identification data.
Sizes to create
This section specifies the number of carvings to create. If the minor
pattern has identification data, the number of sizes of each type may
not be greater than the that can be generated depending on the
selected size table.
Whenever possible, the program will automatically set the number of
carvings to create based on the smaller and larger size and the sizing table.
R 01
Apply colors
If this option is enabled, the generated patterns will take the color
associated with the size in the size table. If cleared, the patterns will
be generated in white.
Create grading
table
If you activate this option, is saved in the pattern data base lower the
table scaling calculated from the smaller and larger patterns and the
intermediate sizes.
Fixed grading
point
This list is enabled when it is activated the option Create table scaling and affects the way of calculating the table of scaling. You must
113