Download User Manual

Controls
Following are detailed descriptions of each of the relevant control panels for the stripper.
These will be referenced in the following instructions.
A. This is the main control panel for the system. The switches are as follows.
A1. MAIN POWER
A2. HEATER
A3. PURGE
A4. UV LAMP
A5. START
A6. RESET
A7. OZONE GENERATOR
B. This is the timer where you will set
the time for your process.
B1. Set Seconds in process time.
B2. Set tens of seconds in process time.
B3. Set minutes in process time.
B4. Set tens of minutes in process time.
B5. Reset the time left on the counter.
B6. Time left in active process. PV=Plate Value
B7. Set time for process. SV=Set Value