Download SpaPilot Manual

Transcript
PERCENTAGE MODE
THE “DAY” FEATURE
day (Displays day then =24 then
hr)
The “Day” setting is not used when in the “Percentage” mode. To use this
feature, change to the “Usage” mode.
®
If your SpaPilot has an “Inline” cell, not an “Over the Wall” cell, then the
following applies:
•
When required, some spa controllers allow the owner to shorten the
spa circulation pump operation to reduce the spa heat gain
(overheating) associated with kinetic energy imparted by the
circulation pump.
•
If the circulation time of the spa is reduced, then the output of the
chlorine generator with an “Inline” cell is reduced proportionally. The
®
SpaPilot maximum sanitizer output capacity will decrease when the
circulation pump run time is reduced. See the table entry, Chlorine
Output - lbs/day (g/day), in the section, Cell Specifications, on page 39 to
determine the SpaPilot® chlorine output if the Spa circulation pump
does not run continuously.
WARNING: A SpaPilot® with an “Inline” cell must be electrically interlocked
with the spa circulation pump to prevent sanitizer generation when there is no
circulation.
WARNING: The sanitizer output capacity of a SpaPilot® with an “Inline” cell
will be reduced if the spa circulation pump hours of operation are reduced.
Supplemental sanitation may be required.
9