Download SpaPilot Manual
Transcript
PERCENTAGE MODE THE “DAY” FEATURE day (Displays day then =24 then hr) The “Day” setting is not used when in the “Percentage” mode. To use this feature, change to the “Usage” mode. ® If your SpaPilot has an “Inline” cell, not an “Over the Wall” cell, then the following applies: • When required, some spa controllers allow the owner to shorten the spa circulation pump operation to reduce the spa heat gain (overheating) associated with kinetic energy imparted by the circulation pump. • If the circulation time of the spa is reduced, then the output of the chlorine generator with an “Inline” cell is reduced proportionally. The ® SpaPilot maximum sanitizer output capacity will decrease when the circulation pump run time is reduced. See the table entry, Chlorine Output - lbs/day (g/day), in the section, Cell Specifications, on page 39 to determine the SpaPilot® chlorine output if the Spa circulation pump does not run continuously. WARNING: A SpaPilot® with an “Inline” cell must be electrically interlocked with the spa circulation pump to prevent sanitizer generation when there is no circulation. WARNING: The sanitizer output capacity of a SpaPilot® with an “Inline” cell will be reduced if the spa circulation pump hours of operation are reduced. Supplemental sanitation may be required. 9