Download AD149 - Zeigermann

Transcript
HIROSE connectors (10)  (13) are provided for single-cable connection to the
mixer. (10) & (11) and (12) & (13) can be used simultaneously.
(10) carries the balanced L-R output and the unbalanced L-R return (stereo-return 1).
(13) carries the balanced AUX 1 and AUX 2 outputs and the unbalanced AUX return
(stereo-return 2).
Pin 1
2
3
4
5
6
7
8
9
10
L-R
Left +
Left Right +
Right Ret 1 R
Shield
Ret 1 L
Shield
Shield
Shield
AUX
Aux 1 +
Aux 1 Aux 2 +
Aux 2 Ret 2 R
Shield
Ret 2 L
Shield
Shield
Shield
Signal
Signal
Signal
Signal
Signal
Signal
(11) carries an unbalanced L-R output and unbalanced stereo-return 1 - for
connection to a camera or DAT recorder.
(12) carries unbalanced auxiliary outputs and unbalanced stereo-return 2 for connection to a camera or DAT recorder.
Pin 1
2
3
4
5
6
L-R
Left
Right
Shield
Ret 1 L
Ret 1 R
Shield
AUX
Aux 1
Aux 2
Shield
Ret 2 L
Ret 2 R
Shield
Signal
Signal
Signal
Signal
POWER OUT (18) is a 4-pin HIROSE connector to supply 12V DC @ 100mA to
power external equipment, eg two non-diversity radio microphones.
Pin 1
2
3
4
Power ground
Power ground
DC
+12V
DC
+12V
Switched
Unswitched
Pin 3 depends on the position of the mixer ON/OFF switch.
Connector (18) may also be used for powering two or three PORT-A-FLEX units.
Each unit has an ‘in’ and an ‘out’ power socket so that several units can be
daisy-chained.
Typical usage could be FLEX-EQ, a headphone distribution
amplifier
35