Download Weihong® Engraving Machine Motion Control System

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.

Single Block
Under Single Block mode, the system will enter into Pause state when the motion speed
becomes 0. To resume machining, the user needs to click
(Start). The system will enter into
Pause state again when the speed becomes 0 again. That is to say, Pause state will be entered into
after the completion of a block, to resume machining, the user needs to click “Start”.
The user can choose this function before or during processing since it is helpful for error
diagnosing and failure recovery.

Handwheel Gear
When “Handwheel Gear” is selected under Auto mode, clicking
, the system will implement
the machining file with the turning of handwheel. When the handwheel is stopped turning, machining
will also stop. The machining speed changes with the turning speed of handwheel.
The user can choose this function before machining and this will help him judge whether the
machining file is correct.

Set Offsets
Right clicking in any part of NC State Widow can also call this function. Its dialog is as shown in
Fig. 5-11.
Fig. 5-11 Set offset
52
Specialized, Concentrated, Focused