Download Setting L2 Ports

Transcript
Chapter 4. Monitoring an OmniBAS Node
OmniBAS LCT
User Manual - Edition 1.0
Monitoring the Control Element
Introduction
This paragraph describes:
• How to set the upper temperature threshold of the OmniBAS-4W subrack’s
processor module and also how to monitor the temperature inside the
module.
• How to check the release of the OmniBAS system
• How to restore the default settings of the OmniBAS system
The monitoring of the Control element of an OmniBAS node is performed
through the Management Control Properties window (that appears when you
select the Control element in the Management Tree).
Regarding the Control element, you can also perform the actions listed in the
following table. For these actions, refer to the corresponding paragraphs
(shown in the Reference column).
Action
Reference
Monitoring the protection status of
the OmniBAS node
Using L2 Properties button.
Par. Configuring the Protection of an
OmniBAS Node (page 26)
Par. 3.2 Configuring Ethernet Traffic (page
46)
Par. 3.5 Setting/ Monitoring System
Synchronization (page 95)
Par. Resetting Processor Module (page 174)
Par. 7.1 Performing Store, Backup or Restore
Action (page 164)
Par. 7.3 Clearing OmniBAS Node
Configuration (page 180)
Configuring system
synchronization
Resetting the processor module
Performing a Store, Backup or
Restore action.
Performing a Clear CFG action.
Continued on next page
106