Download SPAN on OEM6 User Manual

Appendix B
B.1
HG1700 IMU in Universal Enclosure
Disassemble the Universal Enclosure
Disassemble the Universal Enclosure as follows:
1. Using a 3 mm hex bit, remove the M4 screws (they will be reused) and the base, as shown in
Figure 62, Remove Base. Ensure the O-rings come with the base when it is removed, and that they
are not damaged.
Figure 62: Remove Base
2. Using a 30 mm socket, remove the jam nut and free the wiring harness connector from the body, as
shown in Figure 63, Disconnect Wiring Harness from Enclosure Body. Retain the O-ring and the jam
nut for reassembly.
Figure 63: Disconnect Wiring Harness from Enclosure Body
(wiring harness not shown)
120
SPAN on OEM6 User Manual Rev 7