Download Phoenix Interface - Johnson Controls | Product Information

Introduction
About This
Document
This document is designed to help the technician mount and wire the
Johnson Controls, Inc. controller that connects a Phoenix Controls
Corporation Makeup Air Controller to a Metasys or Companion
Network. This interface controller, when properly installed and
commissioned, controls and monitors a wide variety of points relating to
laboratory and fume hood airflow controls.
In addition to a brief overview of the product and its functions, the
document provides detailed information regarding:
●
installation procedures
●
mounting a Johnson Controls lab and fume hood interface (PHX)
●
mounting a Phoenix Controls makeup air controller interface (MIJ) to
Johnson Controls, Inc.
●
wiring details
●
N2 Bus installation
●
Zone Bus communications
●
commissioning and troubleshooting
●
ordering information
Notes: For information specific to Phoenix Controls Corporation, refer to
their Engineering Guide--Laboratory Airflow Controls. The
Phoenix Controls literature is available only to individuals who
have completed certification courses with the Phoenix Controls
Corporation.
If you require further information specific to Phoenix Controls
Corporation and have not completed the certification courses, you
must contact a Phoenix representative or the Phoenix Regional
Sales Manager.
For information on configuring and commissioning the AS-PHX
Controller, refer to the Phoenix Lab and Fume Hood Interface
document in the HVAC PRO for Windows User’s Manual.
Laboratory Controls––Phoenix Interface 3-3