Download Convision V600 A Series

Transcript
Depending on the type of camera connected, some of the following controls will be
displayed instead of the user interface shown in Figure 14: View of a fully controllable
camera.
By clicking on the triangles the camera swivels in the direction of
the arrow. The angle depends on the zoom factor.
Adjusting the zoom factor
Zoom in/Zoom out
Setting the image sharpness range for cameras without auto
focus.
Close-up focus / remote focus
Adjustment of the light incidence in the lens.
Closed iris/open iris
☛ Note: If the configuration protection function is activated, administrator rights are
required for the storage process.
Saving Presets
1. For some controllable cameras you can save specific image sections as preset
sections (Presets). For this purpose, focus on the desired point within the pan
area of the camera.
2. Set the desired zoom factor.
3. Click the diskette icon. A dialog box for saving the current image section related to
a position number is displayed.
4. Click the desired position and assign it a name.
5. Save the data. The dialog box is closed.
6. Now you can always focus on that point by clicking the respective position
number. The names will be displayed as a tool tip whenever the mouse cursor is
positioned on the number. The preset sections can also be addressed due to an
event (refer to Chapter 9.3).
8.2 Playback (Convision V610 A/ 611 A only)
In the "Play" menu you can view the images saved on the available partitions.
Requirements
♦ First of all, you have to create at least one partition on the hard disk (refer to
Chapter 9.5.1).
♦ Start a recording (to start a recording manually, refer to Chapter 8.3, for a timecontrolled or event-controlled start, refer to Chapter 9.3).
♦ After images have been stored on at least one partition, start the playback
function.
Handbuch
- 27 -