Download Alpha Controller User Manual - Stanley Engineered Fastening
Transcript
Alpha Controller Appendix A – Embedded Toolbox Installation Requirements for Alpha Controllers (Ethernet Connection): • Javascript enabled browser Internet Explorer (IE) v6,v7 • Adobe Flash Player v9 or above • http://www.adobe.com • QA1001 Alpha Controller Version 3.0 or above • Q1001 Alpha Controller Version 4.0 or above Connect to the controller using the IP address in the browser. Alpha controllers can also connect through the Controller Gateway using the serial port as described for the Q0001 Kappa controller. Requirements for Alpha Controllers Using the Controller Gateway (Serial Connection): • Microsoft Windows XP (for serial connection to a controller) • Q0001 Kappa Controller v2.0 or above • Javascript enabled browser and Adobe Flash Player described above The Controller Gateway is a Windows based software program that provides a web based interface to an Alpha controller connected via a serial link. Installing the Controller Gateway Using the provided installation media, run the setup program and follow the on-screen instructions. During installation, TCP/IP ports for the web interface and the live event interface can be set. Leave the default values unless you understand their meaning and require a port change for your specific environment. Running the Controller Gateway The installer sets the Controller Gateway to automatically launch each time the computer is started. When Controller Gateway is running, a small icon appears on the system tray or Windows Task bar (typically at the bottom right corner of the screen). Right clicking the Controller Gateway icon displays its menu. From the menu, select the AutoConnect option. Note that Auto-Connect is the default option; this means that double-clicking the Controller Gateway icon also starts the auto-connection process. The auto-connection process launches the default web browser and examines the computers available serial ports. The Controller Gateway looks port by port for a compatible Stanley controller connection. When one is found, the browser redirects to the controller’s main menu. From the menu, setup, maintenance and analysis functions can be performed. If a compatible controller is not found, the auto-connect mechanism offers to try again. If you choose to not try again, the browser is redirected to an “Offline Mode” menu. In offline mode, setups and configuration file exports can be created. These files can be imported to a connected controller in the future. Appendix A – Embedded Toolbox Installation 93