Download View the project brief

Transcript
TECHNICAL SUBMISSION
SECTION C
EMPLOYER’S REQUIREMENTS
Manual prepared by Electricity Networks Department.
State of Qatar Law No. 32 of 2005 and all subsequent amendments concerning
Traffic in the State of Qatar obtainable from Ministry of Justice, Doha.
Any Amiri Decree or current and relevant regulation, notice or circular issued by
the Ministry of Municipal Affairs and Agriculture (including the previous Ministry
of Public Works and the previous Ministry of Industry and Public Works), the
Ministry of Electricity and Water and/or the appropriate local Municipality prior to
the date of the newspaper advertisement of this Tender.
Work Zone Traffic Management Guide and Qatar Traffic Signs Manual –
Volume 1 & 2
1.6
Strategic Plans and Schedules
Contractor should prepare and maintain the following strategic plans and
schedules. On demand by the engineer, contractor needs to submit a copy for
review.
After review if contractor receives any comments or suggestions from the
engineer regarding these documents, contractor shall consider and revise the
documents accordingly to satisfy the engineer’s needs.
Health, Safety and Welfare plan
Quality Assurance Plan
Environment Management Plan
Sustainability Plan
Stake holders Management Plan
Parking, Storage and Logistic Plan
Traffic Management Plan
Contractor’s superintendence and Organisation Chart
Schedule of Sub Contractors and Suppliers
Schedule of Machines / Equipment and Plant engaged in this contract
Schedule of Proposed Machines / Equipment and Plant the contractor has the
ability to supply for the future needs of PWA
1.7
Specific Relevant Codes
All the “crane type vehicles” shall be tested for Safe Working load (SWL)
frequently to confirm they comply with the following Codes of Practice
requirements and the test result must be certified by an approved TPA with
ASHGHAL:
A
B
Mobile and Tower Cranes
Slings
:
:
C
Chain Blocks
:
AA-R 14/15 OM 042 C2 G
On - Call Contract for Rental of
Heavy Vehicles/Equipment
BS: 1757, BS: 2799, and CP: 3010
BS:1290 / 6210, BS EN: 1492 / ISO: 4309, 3481
Part 2 / ASME: B30.9
BS: 3243
C/5
March 2015