Download FlashPro2000 User`s Manual

1. Introduction
FlashPro2000 programmer is dedicated to programming the Texas InstrumentsC2000 DSP
family (TMS320F24xx and TMS320F28xx). Using FlashPro430 programmer the target device
can be programmed via JTAG Interface (4-wires) or via SCI-BOOT Interface..
Each programmer package (Figure 1-1) consists of a microcontroller based adapter,
WindowsTM based software, cable to connect the adapter with the computer’s USB port and two
converters with flat ribbon cables - one for JTAG connection (with 14 wires ribbon cable) and the
second for the SCI-BOOT connection
(with 10 wires ribbon cable).
Communication speed via JTAG is
selectable - up to 3Mb/s or 1 Mb/s - and
allows use of longer JTAG cables if
required - useful in production. To
facilitate high speed communication via
SCI-BOOT Interface, a new Fast Boot
Loader is temporarily downloaded to
RAM of each programmed device, that
allows to communicate with target
device with speed up to 500 kb/s.
To simplify production process
the programming software package can
assign serial numbers, model type, and revision. Each serial number is unique for each programmed
device and is assigned automatically. Several serial number formats are available.
Figure 1-1
There are a number of erase/write options also available. This allows to erase/write all flash
memory, or just the specified fragment of memory. This feature is very useful when only part of
programmed data/code should be replaced. For example this feature can be used to download the
serial number, calibration data or personality data without losing existing program code.
FlashPro2000 - C2000 Flash Programmer
PM034A01 Rev.2
8