Download Operator`s Guide

Continued from the previous page
Are the Pick roller, the Brake roller
and the Pinch rollers dirty?
YES
Clean the dirty parts. (* 5)
5
NO
NO
Install the Pick roller and the
Brake roller properly. (* 6)
YES
Replace the Pick roller unit and
the Brake roller unit if
necessary. (*6)
YES
Have you scanned many sheets?
Check consumables life to ensure
you have not scanned more than
300,000 pages. (* 7)
NO
Contact an authorized FUJITSU
Scanner service provider.
(* 1) For the details on required conditions, refer to the section "6.2 Document Quality"
on page 6-3.
(* 2) For the details on how to set up the Paper Length, refer to "7.3 Setup Mode Details",
"10. Setting Short document scan mode (Paper Length setup)" on page 7-37.
(* 3) For the details on how to clean ADF, refer to "Chapter 3 DAILY CARE" on page 3-1.
(* 4) For the details on how to replace Pas ASSY, refer to "4 REPLACEMENT OF
CONSUMABLES" on page 4-1.
(* 5) For the details on scanner cleaning, refer to "Chapter 3 DAILY CARE" on page 3-1.
(* 6) For the replacement and re-installation of Pick roller unit and Brake roller unit,
please refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1.
(* 7) Check the consumable wear. For the method to check the number of sheets
scanned for each consumable, refer to “7.3 Setup Mode Details”, “9. Abrasion
counter reset” on page 7-34.
5.2 Troubleshooting 5-25
SOLVING COMMON PROBLEMS
Are the Pick roller unit and the Brake
roller unit installed properly?