Download Analysis and Status

7
A small 12V auxiliary supply will also need to be installed to power the Smart Card, at an
estimated cost of $40. In addition, if a different manufacturer is selected, accessories such as bus
bar jumpers may be needed at a small incremental cost also.
Front-panel Metering
For the front panel, we would replace the existing current shunts and analog panel meters
with digital panel meters. Each meter would have a switch beneath to select display of either the
supply voltage or the current output from the supply. For sensing the current, we would install
hall-effect current sensors with a small scaling circuit to bring the signals to the front panel and
out to the DAU for logging. We would also permanently delete the internal fuses installed in the
existing supply chassis that were an attempt to protect the current meters and other equipment
from accidents. This solution is smaller overall, does not create additional voltage drop on the
supply lines, and adds current metering to the logging system.
Digital Panel Meters (DPM)
$130
Current/voltage select switches
$20
Hall-effect current sensors
$110
Scaling and interface board
$100
Buttons, Switches and Lights
The front-panel buttons and switches will be cloned, including the cap colors. We may
choose to select a different mushroom switch for the coil-off function. The price may vary a bit
depending on the lights and other parts selected.
Tricolor LEDs
$5
Pushbuttons
$45
E-stop mushroom switch
$40
Pushbutton caps
$10
Lights
$5
Chassis
We would construct the system using a good-quality 6U height 19” rack chassis with rack
rails. Below is a guess based on a quick Google shopping search. I currently have an inquiry in to
the manufacturer (Schroff) for a quote.
6U height, 450mm deep chassis
$400
Rack rail kit
$100
We may need to add an aluminum chassis base, handles, or other hardware at additional cost.