1
Download User`s Manual
Transcript
3.4.1 Assigning the serial port After startup, the program normally searches the modem to be used to communicate with the Field Monitor on the first available COM port. If your modem (or serial cable in case of local connection) is connected to a different one, the COM port number must be assigned using the following procedure: • Select the icon 8060-SW02 with the right mouse button; • Select Properties; • Add the command COMM=N preceded by a space (in capital letters) at the end of the Destination field where N indicates the serial port to be used; for example, if the 8060 or Modem is connected to port 2, add the command COMM=2. The assigned COM port nr. must be between 1 and 9. • In some operating system the Destination field is enclosed in double quotation marks (“); in this case, the command COMM=N, preceded by a space must be outside as in the example below; • Then confirm by selecting Apply Instructions for use 3-9
