Download Emulex Drivers for Windows V2.41 User Manual

Problem
Answer/Solution
The driver fails to load and an event log
entry states that the driver failed to load
due to memory constraints.
Unload and reload the driver to reset available target IDs. Ensure
that the SAN configuration is correct prior to reloading the driver.
This clears the driver’s consistent binding table and frees target
IDs for new target nodes.
Troubleshooting Cisco Nexus Switch Configuration
Table 13: Cisco Nexus Switch Situations
Problem
Solution
1. Windows creates the NTFS partition ok,
but then reports that "The hard disk
containing the partition or free space you
chose has a LUN greater than 0. Setup
cannot continue". (Dell 1850 server).
2. Windows reboots successfully, but then
gets stuck during the GUI portion of the
installation right from the beginning. (HP
DL385G2 server).
Set up the FCoE switch ports as follows:
no priority-flow-control mode on
untagged cos 0
flowcontrol receive on
flowcontrol send on
spanning-tree port type edge
Emulex Drivers for Windows User Manual
Page 62