Download CE3000-40/60/120

4.21 Setting the OFFSET FORCE (Initial Cutting Force)
This function specifies the cutting force to be applied during initial blade control for checking the cutterblade direction at the start of operation. This is used to control the rotation of the cutter-blade tip during initial blade control when thick media is cut, and is therefore not necessary to specify for media of regular
thickness. The initial setting is “4.” Increasing this setting increases the cutting force.
FEED
AUTO PRE FEED
Step
1
Press the
(PAUSE) key to switch to PAUSE mode.
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
Step
2
Press the
OFFSET
(NEXT) or
(PREV.) key until the following menu is displayed.
FORCE
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
Step
3
Press the
(ENTER) key to display the offset-force setting menu.
EXPAND
OFFSET
FORCE
4
ROTATE
COPY
SORT
RS-232C
COMMAND
Use the
and
keys to select the value to be set, and then press the
(ENTER) key to confirm.
CE3000-40/60: “1” to “31”
CE3000-120:
“1” to “38”
To cancel, press the
(NEXT) or
(PREV.) key.
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
Step
4
Press the
(PAUSE) key to cancel PAUSE mode.
PEN UP SPEED
CHECKPOINT
OFFSET FORCE
This setting is retained in the internal memory even when
the power is turned off.
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
4 – 44