Download User Manual

9
PGMⅢ Programmable Ethernet Control System
Monitor,Administration, and Status. What need to
be changed are only the Setup, Wireless, and the
Administration.
Img.3-6
3. Log in the CR-WIFI 10 (based on Windows XP
OS)
Open IE browser, and type 192.168.1.245 into the
address bar, then press Enter, as shown in the
Img. 3-7:
Img. 3-9
3.1.1.1 Setup
Img. 3-7
Use the username: admin (default) and the
password: admin (default) to log in at the pop up
window, and press Enter, as shown in the Img.
3-8:
Basic settings and network settings can be down
under this option. The interface is as shown in
Img. 3-4.
◆ Basic Setup
Basic Setting: to perform settings of Host name
and Device Name. The Host Name can be used
to access the network, and build up the DNS
through the network.
Host name：Set the controller’s name. A
proper name is suggested for easier manage.
Device Name：Set the device’s name: it can
be any name.
Img. 3-8
Step Three: Wireless Settings
The settings page of the CR-WIFI 10 will open
after procedures shown in Img. 308, and the page
is as shown in Img. 3-9, which includes setting
options as: Setup Wireless AP Mode Security
CREATOR CHINA 2011-03
◆ Network Setup
Network settings: IP can be changed under this
option.
IP Settings：Set up the law for IP assignment:
static or dynamic. The default way is static IP, and
the same default value should be kept for the
controller’s settings. The CR-WIFI 10’s IP can be
changed by the following procedures:
Local IP Address： fill in your IP address,
WWW.CREATOR1997.COM