Download Genesys User Manual

Installation of cards
Master or Slave cards
The installation for the Master and Slave cards is identical.
 Ensure the power is removed from the console, observing the correct
Shutdown procedure.
 Unscrew the two outer screws that hold the faceplate to the console
chassis, labelled 'A' below.
Please be aware that if the optional Dynamics card is fitted, this card will
be attached to the faceplate when it is removed.
▶ Unscrew the blanking plate that is fitted to the lower half of the plate,
removing the two screws labelled 'B' above.
▶ Insert the AD/DA card into the lowest slot in the available space in the
console, (with the components facing down), ensuring that the card's
rear-edge connector makes a firm contact with the connector on the
console backplane.
▶ Screw the faceplate back to the console chassis (using the 'A' screws),
making sure that all the connectors on the AD/DA card (BNC, FireWire, Dsubs etc) clear the faceplate.
▶ Screw the four jack-posts either side of the D-sub connectors, plus the
two nuts & washers over the BNC connectors into place.
There is a small double-ended spanner included with the kit of parts for
this purpose.
On consoles with a different Channels faceplate (manufactured before May
2010), you will also be sent a new faceplate with the AD/DA card.
If applicable, this should have the Dynamics cassette fitted to it before the
AD/DA card is fitted in the console.
- 138 -