Download Mantis User Manual - PC Version

General Operations
The Mantis is operated via menu-driven software. It is simple to use
and connects to wires, cables, or harness wiring via a terminal block
inside the Mantis unit. To ensure safe operation of the Mantis,
follow the instructions carefully and pay attention to the warning
and caution symbols. Failure to observe warnings can result in
severe injury or death and can damage the unit.
Physical Setup
• Mount the Mantis in the desired location.
• Connect the included A/C to D/C power adapter to the Mantis.
Connecting to a Cable/Wires
Connect the cable or wires to the terminal block of the Mantis to
perform a test.
Fault Location Testing
The Mantis Fault Location test is not meant to be used on powered
cables. Connect the cable or wires to the terminal block of the
Mantis to perform a test.
Live IFD (Intermittent) Test:
To monitor the cable length, Mantis can be connected either near
the source or near the load. The images on the next page illustrate
connections with the Mantis near the source or near the circuit load.
Live Sweep (Intermittent) Test:
The Live Sweep test maximizes accuracy on very long length cables (>
1000 feet). Mantis can be connected either near the source or near
the load. The images on the next page illustrate connections with the
Mantis near the source or near the circuit load.
15