Download Gx Time Chart Recorder Application User`s Manual

Page 9 of 37
As mentioned in Section 1, voltage data are time-stamped using either the
data-logger’s internal clock or the GPS clock and the clock option, or
options, available for time-stamping depends on the reading mode selected
for the voltmeter.
Either the internal clock or the GPS clock can be used to time-stamp voltage
data with the “Single Read” voltmeter reading mode selected, only the
internal clock can be used with the On/Off Pairs (D.S.P.) and the On/Off
Pairs (Min/Max) voltmeter reading modes selected and, finally, only the
GPS clock can be used with the On/Off Pairs (GPS Sync.) and the Single
Read (Cycle Zone Tag) voltmeter reading modes selected.
Single Read:
With this voltmeter reading mode selected, the screen shown below will be
displayed.