Download User`s Manual Template
Transcript
- The board needs to be connected to a PC using a parallel cable that uses pins 1-25 as there is a watchdog on pins 18 and 19 that disables the outputs if the board is not connected to a PC. There are some parallel cables out there that use only pins 1-17, use a multimeter to verify continuity between these pins. - You should have 5vdc on the EN terminal. This is for external hardware disable on the board. You can use a jumper between the 5vdc in the power terminal and the EN terminal. - In the case of boards with built in Safety Charge Pump, the SCHP must be configured and active, or you can disable the SCHP in the board by moving the jumper to the disable position. 11. DISCLAIMER: Use caution. CNC machines could be dangerous machines. DUNCAN USA, LLC or Arturo Duncan are not liable for any accidents resulting from the improper use of these devices. This product is not fail-safe device, and it should not be used in life support systems or in other devices where its failure or possible erratic operation could cause property damage, bodily injury or loss of life. User’s Manual Page 11