Download PDF - Oy LAI
Transcript
User manual LM 486 4. Open the hydraulic oil tank breather cap (B) on the left side of the engine compartment, and pour the correct grade of oil through the filler neck until the oil level is visible in the sight glass (C). 5. Close the breather cap (B). 6. Start the engine and let it run for a few minutes. 7. Stop the engine and check the oil level, add oil as necessary. 8. Start the engine and check that all plugs and connections are tight. 9. Turn and attach the underpan in place. 6.9.7 Cabin fresh air filter replacement (33) Figure 91. ► ► ► Open the hatch (1) below the right cabin side window. Remove the filter (3) and dispose of it according to regulations. Install a new filter and close the hatch. 6.9.8 Battery check (34) Figure 92. The battery (A) is located behind the rear right service hatch. The battery is maintenance-free and requires no special service. ► Remove the fasteners on the bottom edge of the service hatch, pull the hatch outward from the lower edge and lower it. ► Check that the battery cables are properly attached, and that the cable connectors and the outside of the battery are clean. ► Check that the battery is firmly attached. ► Attach the service hatch. Info! The main power switch may be used to disconnect all electrical connections between the battery and the machine. 64 06 Maintenance Ver. 27102014