Download User Manual - Ability Ireland
Transcript
QD. TRINST1.P65 iss.7/GJ-06/09 9 Adjusting Thoracic height on Width Adjustable Lateral Supports The height of the thoracic support should be set up as described earlier, with a three finger gap between the user's armpit and the top edge of the thoracic support. To adjust the height of the thoracic support with width adjustable laterals, use the dumbell spanner in the tool kit to undo the two bolts on the ends of the painted section of the thoracic control assembly. With these bolts undone, slide the thoracic support up or down to the desired height. Once in place, tighten up the bolts and ensure they are firmly tightened before use. Fastening Support Straps The straps must fit the user snuggly. Loosely fitting the straps should be avoided as the user may come out of position on the saddle and become trapped by the straps. Fit the free end of the strap through the buckle on the other end and pull until the user is held firmly but their breathing is not restricted. Fasten the buckle by pushing the lever into the body of the buckle. To undo, tug the free end of the strap forwards so that it pulls the buckle open. Quest 88 limited, Aston Street, Shifnal, Shropshire, TF11 8DW tel: +44 (0)1952 463050 fax: +44 (0)1952 463077 www.quest88.com email:[email protected]