Download SDC15 Single Loop Controller User`s Manual for

Chapter 5. SETTINGS BEFORE STARTING OPERATION
■ Event main setting setup
(1) In the operation display mode, keep the [para] key
pressed for 2 sec. or longer.
>> The unit then enters the parameter setting mode.
pv
sp
mode
rdy
man
ev1
ev2
ev3
ot1
ot2
man
ev1
ev2
ev3
ot1
ot2
para
(2) Press the [para] key several times.
>> Display the parameter setting [E1: Internal event 1
main setting].
pv
sp
<
<
(3) Press the [<], [ ], or [
[E1].
] key to change the set value in
mode
rdy
para
Setting range: -1999 to +9999
The decimal point position is changed corresponding to the event operation
type.
For a part of the event operation types, the setting range becomes 0 to + 9999.
>> When no keys are pressed for 2 sec. or longer, the flashing of the numeric
value is stopped to set the currently displayed value.
(4) Press the [mode] key.
>> The display is returned to the operation display.
Handling Precautions
• The displays of the internal event 2 to 5 main settings are [E2], [E3],
[E4], and [E5].
• When the internal event operation type is set at [0: No event] or the
operation type does not need any main setting, the internal event
main setting is not displayed.
5-21