Download M20 User manual

OK
2.3.1.3 Set to factory-defined configuration (&F)
Table: Syntax (&F)
Command
Possible response(s)
&F
Description
This command instructs the DCE to set all parameters to default values
specified by the manufacturer, which may take into consideration hardware
configuration switches and other manufacturer-defined criteria.
Defined values
0
set parameters to factory defaults.
(other)
Reserved for manufacturer proprietary use.
Result codes
OK
if value is valid.
ERROR if value is not recognized or not supported.
An OK result code for this command is issued using the same rate, parity, and
format as the DTE command line containing the command, but using the
factory-defined values for other parameters that affect the format of result
codes (e.g. Q, V, S3, S4) and dependent upon other commands that may
follow on the same command line.
Informative Examples
-Initial the HyperTerminal
-Initial the MS
-AT Command
AT&F
OK
138
©2003 BenQ Corporation.
Confidential Property
M32 AT COMMAND LIST
Version: 0.3.0-2003/05/16