Download Web Tools Administrator`s Guide
Transcript
SNMP configuration 16 3. Double-click a community string in the SNMPv1 section and enter a new community string. 4. Double-click a recipient IP address in the SNMPv1 section and enter a new IP address. 5. Click Apply. Setting SNMPv3 configuration parameters NOTE The port number is not included. To set SNMPv3 configuration parameters, perform the following steps. 1. Open the Switch Administration window as described in “Opening the Switch Administration window” on page 33. 2. Select the SNMP tab. 3. Select a user name from the User Name menu in the SNMPv3 section. NOTE The list is scrollable. If you do not see your user name, scroll down using the scroll bar or by clicking the User Name heading. 4. Double-click a recipient IP address in the SNMPv3 section and enter a new IP address. 5. Select a trap level from the Trap Level menu. 6. Optional: Select the Enable SNMPv3 Informs for all Trap Recipients check box to enable or disable inform requests for all trap recipients. 7. Enabling SNMPv3 informs allows you to enter the Engine ID. The Engine ID is required to authenticate the inform request. If informs request is disabled, the SNMP manager does not send a response to the sender. 8. Click Apply. Changing the access control configuration NOTE The port number is not included. To change the access control configuration, perform the following steps. 1. Open the Switch Administration window as described in “Opening the Switch Administration window” on page 33. 2. Select the SNMP tab. 3. Double-click an access host IP address in the Access Control List section and enter a new host IP address. You can enter an IP address in either IPv4 or IPv6 format. When you use the IPv6 format, you must include a prefix; for example, fec0::2002/64. NOTE The list is scrollable. If you do not see your user name, scroll down using the scroll bar or by clicking the Access Host heading. Web Tools Adminstrator’s Guide 53-1002152-01 195