Download Sun WorkShop 6 Installation Guide

2. Start lit_tty by typing:
# /etc/opt/licenses/lit_tty -f license-file
Replace license-file with the path to the file where you saved the license information
that Sun emailed to you (see “Saving an Email License to File” on page 22). Refer to
the lit_tty man page for more information.
3. Decide if you want the displayed licenses installed.
■
■
If you want the displayed licenses installed, type y. lit_tty installs your
licenses.
If the licenses that are displayed are not the licenses you want to install, type n.
See “Contacting Technical Support” on page 3 for technical support.
4. Exit from superuser privileges by typing:
# exit
Fax License Installation
If you received your license information from the Sun License Center through a fax,
follow these instructions to install your licenses.
Note – If you have not filled out a License Request Form, see Chapter 2 for
instructions.
1. Become a superuser (root) by typing the following at the command line:
% su
Password: root-password
2. Start lit_tty by typing:
# /etc/opt/licenses/lit_tty
3. In the Select Product to License screen, type an x next to WorkShop6.0.
If instead of the Select Product to License screen you see the Select Product screen,
skip to step 4.
Press Return to navigate down the product list to WorkShop6.0.
4. In the Select Product screen, type an x next to the product for which you want to
install a license.
Your Proof of License Certificate provides information about the product(s) you
purchased. If you do not want to install a license for the product where the cursor is,
press Return to navigate to the next product on the list.
52
Sun WorkShop 6 Installation Guide • May 2000