Download FREEDOM F-64 PROGRAMMING INSTRUCTIONS

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN
CONTROL PANEL FIRMWARE VERSION 30 OR LATER.
IMPORTANT PROGRAMMING INFORMATION
The following System and Keypad Options must be programmed for proper panel operation:
•
•
•
•
Automatic Interior Bypass/Easy Exit (address 1424, option 1)
Interior Normally Bypassed (address 1422, option 1)
Disable Code Required for EZ Bypass (address 1424, option 8)
Easy Arming (addresses 1440-1446, option 6)
IMPORTANT NOTICE
F-64 panel version 30 requires the use of the following version programmer:
• F-64PROG Version 01
Upon entering program mode, the programmer display will flash the control panel firmware version, followed by
the programmer firmware version:
• F-64PROG : [3001]
If Gemini keypads are installed in the system (in addition to the required Freedom F-64TP or F-64TP-H Touchpads), the following version keypads must be used:
•
•
•
•
GEM-K1CA Version 9B
GEM-K2AS, Version 7
GEM-K3DGTL, Version 3
GEM-K4/K4RF, Version 2
Differences between the GEM-P1664 and the Freedom F-64 Control Panels:
The GEM-P1664 control panel and the Freedom F-64 V30 control panel are identical, except for the following:
• The "Classic" Gemini RP-Series keypads cannot be used with the Freedom F-64 V30 control panel.
• The Perimeter Group Bypass zone feature is exclusive to the Freedom F-64 V30 control panel.
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com