Download LabVIEW Fundamentals

Transcript
Chapter 5
Building the Block Diagram
Adding Terminals to Functions
You can change the number of terminals for some functions. For example,
to build an array with 10 elements, you must add 10 terminals to the Build
Array function.
You can add terminals to functions by using the Positioning tool to drag the
top or bottom borders of the function up or down, respectively. You also can
use the Positioning tool to remove terminals from functions, but you cannot
remove a terminal that is already wired. You must first delete the existing
wire to remove the terminal.
Refer to the Using Wires to Link Block Diagram Objects section of this
chapter for more information about wiring objects.
Built-in VIs and Functions
The Functions palette also includes the VIs that ship with LabVIEW. Use
these VIs and functions as subVIs in an application to reduce development
time. Click the View button on the Functions palette and select Always
Visible Categories»Show All Categories from the shortcut menu to
display all categories on the Functions palette.
Refer to the Using Built-In VIs and Functions section of Chapter 7,
Creating VIs and SubVIs, for more information about using the built-in VIs
and functions.
Refer to the LabVIEW Help for detailed information about all built-in VIs
and functions.
Express VIs
Use the Express VIs for common measurement tasks. Express VIs are
nodes that require minimal wiring because you configure them with dialog
boxes. The inputs and outputs for the Express VI depend on how you
configure the VI. Express VIs appear on the block diagram as expandable
nodes with icons surrounded by a blue field.
Refer to the Getting Started with LabVIEW manual for more information
about using Express VIs.
© National Instruments Corporation
5-5
LabVIEW Fundamentals