Download Multiprise 3000 Technical Introduction

Transcript
The AWS34XX device manager potentially emulates any of the standard
mainframe tape types when using the 4mm drive; however, we recommend that it
be used to emulate 3480 drives with the IDRC feature. P/390 experience
indicates these drives are not completely suitable for extensive backups or for
wide interchangeability of tape data. IBM recommends that the 4mm drive be
used primarily for receiving software products and fixes.
Using the differential SCSI interface and suitable cables, a number of tape drives
can be chained together and supported by the AWS34XX device manager.32
However, the system, as delivered, makes provision for only two drives (in
addition to the 4mm drive). AWS34XX is a combined OS/2 device driver and
device manager. It appears in the CONFIG.SYS file for OS/2, and needs to have
the SCSI address(es) of the tape drives specified with it if multiple SCSI tape
drives are used.
Tape drive emulation can be slightly complex. It is possible, for example, to
emulate a 3490E drive (36 tracks) using a 3480-type (18 tracks) drive. Such
cross-device emulation usually works, but is not recommended. (Such emulation
may fail in error recovery situations, and so forth.) IBM generally recommends
that the physical tape drive type should correspond closely to the emulated drive
type. (No mainframe tape drive type corresponds closely to the 4mm drive. We
generally recommend that it be emulated as a 3480 with the IDRC feature.)
An special case occurs if a SCSI drive is used that can read and write both 18
and 36 track tapes. No standard mainframe drive does this, 33 but the 3490-F01
has this ability. AWS34XX can use one of these drives to emulate two tape
drives, one for writing 18 track tapes (3490) and one for writing 36 track tapes
(3490E). (Both 18 and 36 track tapes can be read in either case.) Only one of
the two logical drives can be online to OS/390 at any given time.
Another option is a DLTdrive, such as the IBM 7205-311 unit. These have proven
quite reliable and fast when used with P/390 systems. They are best used for
emulating 3490 drives. However, few mainframes can accept DLC tapes. At the
time of writing, the DLT drives had not been tested for the Multiprise 3000
systems and no formal IBM support exists.
The AWS34XX device driver/manager also provides an OS/2 interface 34, and the
XTAPE utility is included with Multiprise 3000 to use this interface. AWS34XX can
sense when one of its drives is varied online or offline by OS/390, and it uses this
information to permit or prohibit accessing the drive with the XTAPE utility, which
is described in “The XTAPE Utility” on page 54.
Emulated tape drives are defined through the Emulated I/O Configurator,
described in the next chapter. Appendix D describes the customization of
AWS34XX in more detail.
3.7.0.7 AWS2821 (PC Printer Usage)
A Multiprise 3000 system can use many types of channel-connected printers, and
these would be the primary choices for production printing. However, smaller
operations, and especially development organizations, often have very minor
32
We are aware of a P/390 system with six SCSI tape drives, but this is unusual. The typical P/390 system may have one of these
mainframe-type tape drives, in addition to its 4mm drive.
33
A standard 3490E drive can read both 18 and 36 track tapes, but it can only write 36 track tapes.
34
This is not a documented programming interface, and is intended only for use by the XTAPE utility.
40
Multiprise 3000 Technical Introduction