Download FlexDSL ORION 2(+)
Transcript
User Manual 3.6 Repeater Orion 2 Description of FlexDSL Orion 2 interfaces 3.6.1 xDSL interface The operation modes described below refer to the line interface of the device. The FlexDSL Orion2 devices can have 1, 2 or 4 xDSL interfaces. The interfaces can operate independently of each other. All independent xDSL interfaces and groups of xDSL interfaces operating in the multipair mode can be configured separately from the other xDSL interfaces. The multipair mode, the reservation mode and the mode of automatic configuration detection naturally limit independent functioning of the interfaces. All interfaces support the plesiochronous data transmission. It means that reference clock frequencies, which are used to clock data transmission, can transmit data in different directions in one xDSL link. The clock frequencies of different xDSL channels are completely independent if they do not operate in the multipair mode. If the xDSL channel is configured to operate in the independent mode (normal settings), it can simultaneously transmit one or several E1 streams and one WAN stream. This transmission is plesiochronous. All E1 streams received by one DSL interface should use the same clock frequency in one direction. Table 3.3 represents line settings in the independent mode. Table 3.5 Line settings in the independent mode. Mode Coding type Baserate Manual configuration, Master, Slave PAM16 3..60 PAM32 12..89 Autodetection, Master PAM16 Auto (3..60) PAM32 Auto (12..89) Autodetection, Auto Auto (3..89) Slave (PAM16, PAM32) Data transmissio n rate Standard Baserate* 64 kbit/s Annex A, Annex B, Annex AB (autodetection) Annex (autodetection) AB Annex AB (autodetection) 3.6.1.1 Master/Slave/Auto To establish a connection, it is necessary that one transceiver has to be a Master and the other – a Slave. In this case, the connection is controlled by the Master device. The regenerator can also automatically detect the “Master/Slave operation modes. In this mode, the regenerator automatically detects from the side of which of line interface the Master device and the Slave modem are located. The MASTER ON/OFF command (the Configuration management menu) is used to configure the Master/Slave operation modes. 21