Download Mech-Q Tutorials

Command: Insertion Point:
Select the point of the diffuser enter point (Flexible duct turned end point).
The diffuser will be drawn at this point.
The Rotation dialogue will now be displayed – Select the 0.0deg button
The flange will now be drawn at the correct rotation on elbow face.
Command: Annotation insertion <point>/(Enter or S to Skip):
Select the insertion point to draw the Annotation Label (or use the Skip
option to draw no label)
This concludes the duct drawing tutorial.
The software is also equipped with Auto-BOM. The procedure for
generating a ducting BOM is very similar to that described under the piping
tutorial (Section 2.4). To start the ducting auto-BOM use the “BOM” tab in
the Straight Ducting main dialogue.
69