Download User Manual - Data Loggers

MadgeTech Operating Manual
The reading rate can be selected to determine its data recording frequency.
When selected, the maximum recording time will be calculated for the particular device, based on its internal memory capacity, and displayed in Log
Time box. Once started, the device will continue to record readings until its
memory is full, unless the Wrap Around feature is enabled. When full, the
data recorder will stop recording additional readings, then place itself into a
low power state to maximize battery life. The data stored in the data logger
is always preserved (even in the case of battery failure) unless the device is
reset or started. When re-started the existing readings are then overwritten.
For some types of data loggers which have the stop feature, the following
window may appear:
Manual Stop (default option for logger operation)
The device will continue to record data until the memory is full, or until the
device is stopped manually using the MadgeTech software.
Stop on Date
The user can specify a time at which the device will stop taking readings to
memory. A stop date can be specified up to a year in advance.
Note: If the Wrap Around feature is activated a stop date will not be possible
to set.
Page 68