Download User manual - Ntn

Transcript
7.4.7 Disabling and Enabling the Minimum level sensor (from fw 1.15 version)
If you need to disable the minimum level alarm from Press Reset and down arrow.
The alarm LED
(motor block LED) will blinks for about 3 seconds confirming the setting, after which you can release the
buttons. In this mode, the pump signals the minimum level via corresponding blinking LED and switching the remote alarm signal
but continues to operate normally according to the cycle time setting.
+
Minimum level disable
To re-enable the minimum level alarm press and hold the Reset button and up arrow. The alarm LED
for about 3 seconds, after which you can release the buttons.
+
(motor block LED) blinks
Minimum level enable
* NOTE: In case there is an alarm for over / under voltage during the 3 seconds required to enable/disable the
minimum level, the fault LED will not blink but remain lit.
12