Download Thermo Scientific Orion

Analyzer Operation | Chapter 3
Enters setup mode
System setup mode at the
last parameter used
by the operator
PASS, DATE, TIME, LOG,
RSET, DISP, CH1, CH2, MDL,
MEAS, HOLD, TCMP, TADJ,
ALRM, mAMP, mADJ, TEST,
CAL, PH, COND, DYN
Moves to the next digit
Use to edit values
When moved to final digit,
the system will wrap around
to first digit
Enters test mode
Use to advance through
sequence of displays
DIAGNOSTICS will appear
in top right of screen
Scroll down digit numbers
Scroll down through a list
of options in setup and cal
modes
Use to edit numeric values
Use to select available
options
Enters log view mode
Use to view data in
calibration, measure and
status logs
+/- function
Enters negative/positive
sign when editing numbers
Enter function
Use to accept value or
selection displayed on
screen and store value or
selection in memory
Enter function (in test mode
only)
Use in test mode to display
additional information for
selected menus
Exit to measure function
Use to exit setup or cal
modes and enter the
measure mode
Last screen function
Use in setup and test
modes to return to the
previous screen or menu
Decimal point function
Use to set the decimal point
position in certain menus
with numbers that require a
decimal point
0 through 9 selectable by
digit, first digit sometimes
selectable 0 through 19
Analyzer automatically
enters measure mode when
first turned on and after
calibration
Use of the Setup Mode
Before the first sample measurements can be taken, the setup mode should be programmed
and a successful calibration must be performed by the operator and stored in the memory of the
analyzer.
Thermo Scientific
2117LL Low Level Chloride Analyzer | 3-3