Download ICS-Series Photodiode Array Detector Manual
Transcript
2 • Description Lamp Power Supply Board The lamp power supply controls the deuterium and tungsten lamps. In addition, it supplies power to the variable speed fan that cools the optical bench. NOTE The fan speed is controlled automatically. Changes in fan speed may be audible, especially when the lamp selection is changed or the ambient temperature fluctuates. SHOCK HAZARD—Components used to ignite and operate the deuterium lamp are at high potentials. DANGER D'ÉLECTROCUTION—Les composants utilisés pour allumer et faire fonctionner la lampe au deutérium sont à des potentiels élevés. STROMSCHLAGGEFAHR—Die Komponenten zum Zünden und Betreiben der Deuteriumlampe führen Hochspannung. Der Service darf nur von qualifiziertem Personal durchgeführt werden. Preamp Board The photodiode array is connected directly to the preamplifier. The preamp gain is automatically adjusted to compensate for system variables such as lamp intensity. Analog-to-digital conversion of the signal occurs on the Preamp board. Preamp output is directed to the Data Processing board. Data Processing Board The Dionex PDA Moduleware resides on the Data Processing board. This board provides the digital signal processing and conversion to log ratios when absorbance is measured. Also located on the Data Processing board are the connectors for USB and TTL/relay communications, as well as four BNC connectors that provide the analog (recorder) outputs. Doc. 065378-01 1/12 21