Download Geodimeter® System 600 and 600 Pro

PRE-MEASUREMENT CHAPTER 2
GEODIMETER SYSTEM 600
Test Procedure (cont) Tilt of horizontal axis
MNU
5
TEST
Test
10:20
Tiltaxis?
D
w ocu
w m
w
.k en
ol to
ln d
er e
la sc
br ar
an ga
a. do
cl
d
e
ENT
If you answered YES (ENT), the
question for measurement of the tilt of
the horiz. axis appears. Press YES
(ENT).
Note!
If you consider it unnecessary to
measure the tilt of the horizontal axis,
you can avoid this by answering No to
the question.
Test 10:20
Tiltaxis
Face II: 0
* Servo: Rotate the instrument to C2.
Wait for a beep and aim at a point
which is at least 15gon above or below
the horiz. plane.
Press A/M in front after each sighting.
or
7
Note! ☛
Press
Rotate the instrument to C2*, aim at a
point which is at least 15gon above or
below the horiz. plane.
Press A/M in front after each sighting.
Press
in front
Press the A/M key in front. A beep is
heard...
Press
in front
Make at least two sightings to the
point, approaching from different
directions, and then press A/M in
front.....
A/M
if you
have a
control
unit at
the front.
See next page
Note!
The same number of sightings must be
made in both C2 and C1.
1.2.24