1
Download Panasonic FP0 Controller User`s Manual
Transcript
FP0 Address R9029 (*Note) R902A (*Note) R902B (*Note) R902C to R902F R9030, R9031 R9032 R9033 R9034 R9035 R9036 R9037 R9038 R9039 R903A R903B R903C R903D Name External interrupt enable flag Description Turns on during forced on/off operation for input/output relay timer/counter contacts. Turns on while the external interrupt trigger is enabled by the ICTL instruction. Interrupt error flag Turns on when an interrupt error occurs. Not used - Not used - Forcing flag RS232C port mode flag Printout instruction flag Rewrite during RUN flag S-LINK I/O communication error flag S-LINK communication status flag RS232C communication error flag RS232C reception completed flag RS232C transmission completed flag High-speed counter control flag High-speed counter control flag High-speed counter control flag High-speed counter control flag R903E, Not used R903F Note) Used by the system. When “General-use port” is selected, “K2” goes on. Turns on while a F147 (PR) instruction is executed. Turns off when a F147 (PR) instruction is not executed. This is a special internal relay that goes on for only the first scan following the completion of rewriting in the RUN mode. (CPU Ver. 2.1 or later available) Turns on when the S-LINK error (ERR 1, 3 or 4) occurs using S-LINK system. Turns on when communication is taking place with an SLINK input/Ooutput unit. Turns on when the serial data communication error occurs. Turns on when a terminator is received during the serial data communicating. Turns on while data is not send during the serial data communicating. Turns off while data is being sent during the serial data communicating. ch0 Turns on while the high-speed counter instructions F166(HC1S) to F170(PWM) are executed. ch1 Turns on while the high-speed counter instructions F166(HC1S) to F170(PWM) are executed. ch2 Turns on while the high-speed counter instructions F166(HC1S) to F170(PWM) are executed. ch3 Turns on while the high-speed counter instructions F166(HC1S) to F170(PWM) are executed. - 14-17 Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]
