Download User Manual

2.7 $AA0Ci
(For EX9033P/33PM/15/15M/36P/36PM)
Description: Perform zero calibration on the specified
channel.
Syntax:$AA0Ci[CHK](cr)
$
delimiter character
AA address of setting/response module (00 to FF)
0
command for the zero calibration
Ci
specifies the channel to be calibrated
(EX9033P/33PM: i=0~2, EX9036P/15/15M: i=0~5)
Response: Valid Command:
!AA
Invalid Command:
?AA
Example:
Command :$010C0
Receive : !01
Perform address 01 zero calibration on channel 0, return
success.
Command : $020C2
Receive : ?02
Perform address 02 zero calibration on channel 2, return not
enable calibration before perform calibration command.
Note: This command must be sent before the “span
calibration” command, $AA1Ci, is used.
21