Download MCB251 Evaluation Board

Transcript
MCB251 Evaluation Board User’s Guide
Chapter 2. Setup
The MCB251 evaluation board requires power and a serial connection to a PC
running the MON251 terminal program. Before you start, make sure you have
satisfied the following hardware and software requirements.
Hardware Requirements
n
The MCB251 Evaluation Board.
n
A serial cable, 9-pin male to 9-pin female, 1-2 meters long, wired one-to-one.
n
A PC with an available RS-232 port. If the port has a 25-pin connector, a
9-pin male to 25-pin female adapter may be required.
n
A device programmer is required to program any EPROMs or other
programmable devices.
Software Requirements
n
The Keil MON251 terminal program (MON251.EXE) or the Keil dScope for
Windows with the MON251.DLL driver. The Keil MON251
software/firmware is already programmed into the EPROM provided on the
MCB251 board.
n
Microsoft Windows version 3.1, 3.11, Windows 95, or Windows NT.
3