Download Version 10 Addendum to the User`s Manual Introduction

CZ Point Cloud Updates
Vertical Orientation
Align the point cloud to set the vertical angle of the drawing. Pick two points, bottom and top of the point cloud
that will translate as the bottom and top of the drawing.
Elevation Adjust
A new option was added that lets you manually pick the ground plane point.
A good time to use this tool would be when establishing the “belt” or “slice” area for drawing a crush outline.
With 2D Trace Mode ON all of your points would be placed at the selected ground plane.
FARO Technologies – 4790 SW Watson Ave – Beaverton, OR 97005 800-641-9077
Page 21