Download 9 - JED Microprocessors Pty. Ltd.

These is only one audio input and no output, so audio control in the projector is NOT supported. Use a T441 or T461.
Reply mode is supported for manual closedown detect.
RS232 connections to Kaga -Taxan - Plus projectors
These use a 9-pin-D9 male on the projector, female on cable. Comms is at 19200 baud, 8 bits, no parity, 1 stop.
Function/Direction
T460
“projector”
Connection
“Serial” Port
Connector
Ground
Ground
9-pin D-sub pin 5
Data from T460 to projector
Tx
9-pin D-sub pin 3
Reply data from projector to T460
Rx
9-pin D-sub pin 2
Plus 9 volt CTS/DTR to projector
N/C
N/C
1
2
6
3
7
4
8
5
9
D-sub 9 female
solder side
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual.
TEAC Plasma:
PLMSDM1060, PLMHDM1065, PLMHDM1275
The following table shows the mapping of T460 channel number, the string sent, and the input associated with that channel in
the manual, and how it is identified on the on-screen menu:
T460 Channel
TX codes
Input name in manual
Function as identified on screen
1
91h 01h
AV1 Composite
Video 1
2
91h 02h
AV2 S-Video
Video 2
3
91h 03h
AV3
Video 3
4
91h 04h
Component 1
5
91h 05h
Component 2
6
91h 06h
RGB 9-pin D-sub (Analog)
PC Analog
7
91h 07h
DV1
PC Digital
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.
RS232 connections to TEAC Plasma with D9
These use a 9-pin-D9 male on the plasma, female on cable. Comms is at 9600 baud, 8 bits, no parity, 1 stop.
Function/Direction
T460 “projector” Connection
“Serial” Port Connector
Ground
Ground
9-pin D-sub pin 5
Data from T460 to projector
Tx
9-pin D-sub pin 3 (RXD)
Reply data from projector to T460
Rx
9-pin D-sub pin 2 (TXD)
Plus 9 volt CTS/DTR to projector
“RTS”
N/C
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual.
T460/461/T462 Manual 9th Sept 2015 Part B 3.84 release © Jed Micro Pty Ltd
62