Download ADMS-4B Help File.

Transcript
Memory Channel Programming
71
two columns may change when the file is opened again if the offset can be
figured to a 50kHz value and the direction set to plus or minus. This gives
you back functionality on the radio that is lost with a channel marked "Split".
If you see this change, ignore it. The radio will function exactly the same
when you use it with these different settings.
You are finished with this entry unless you need to enter Name, Tone or other details for
this memory channel.
Offset Frequency: Standard offsets include 100, 500, and 600 kHz and 1.0, 1.6, 3.0,
5.0, and 7.6 MHz. Although an Offset Frequency is displayed for every memory channel,
it is not used by the radio if the Offset direction is set to Simplex.
Yaesu radios can use an Offset Frequency of any value in 50 kHz steps (i.e.,
any value ending in .x00 or .x50 where x is any digit from 0 to 9) with a Plus or
Minus Offset Direction. This gives you the ability to use the Reverse function
of the radio although your frequency pair is not separated by a standard offset
value.
A nonstandard Offset Frequency value is entered by typing it into the
Offset Frequency field after the Receive Frequency has been entered. Then
select Plus or Minus in the Offset Direction column and watch the
Programmer calculate the Transmit Frequency.
Values would be entered as an exact value including the decimal to denote
kHz. For example, given the pair 146.650 and 147.300, the Offset Frequency
entered would be .650 (decimal – six – five – zero) with a Plus Offset
Direction. Without the decimal, an error is raised in the Programmer that a
valid Offset Frequency should be entered.
As another example, given the pair 147.255 and 145.940 could not be
entered with an Offset Frequency and an Offset Direction. The resulting offset
for this pair us 1.315 MHz, which is not on a 50 kHz step. This pair requires
entry of both the Receive and Transmit frequency with the Offset Direction set
to Split. In this case, any value that appears in the Offset Frequency column
will be ignored by the radio when it uses this memory channel.
The default Offset Frequency depends on the band of the Receive Frequency
being entered (i.e., 2M Band is always 600 kHz, 430 Band is always 5.0
MHz, etc)
As in Splits, the Offset Frequency value is ignored when the Offset Direction
is set to Simplex.
Offset Direction: Select
Simplex - transmit and receive frequencies are the same;
© 2012 RT Systems, Inc